Witam
Czy ktoś się może spotkał z firmwarem do Olka 8080 o numeracji 757-78. Na oficjalnej stronie Olympusa jest tylko 75. Czy może ktoś wgrywał, jeśli tak to czy ma jakieś refleksje z tym związane(co to dało, czy warto, czy wiąże się to z jakimś ryzykiem). Poniżej przedstawiam informacje znalezione na innych stronach niestety po angielsku
Olympus C-8080WZ 757-75~757-78
- When in BULB mode for 40 seconds with Noise Reduction OFF and using ISO 400 there is stray light in the exposure
- After the external flash is fired, the flash charging indication is not displayed
- The camera may lock-up when using a defective memory card
- Pixel Mapping does not function properly
- When the camera is used in SDK mode, the Camera Controls cannot be used
- With the FL-50 flash and the camera lens set to the widest angle, the focal length value will not indicate less than 35 mm
- When in RAW mode the minimum aperture is incorrectly indicated with any software
Strona: http://forum.hslab.pl/viewtopic.php?p=27830
Firmware
Here are the update instructions for the firmware.
The latest firmware available for the Olympus 8080 is v757-78 (note: to get this firmware send your camera to Olympus). Here is an overview of the changes between firmware versions:
757-74 to 757-75
The update corrects the following errors:
1. Turn PW-ON and as Auto-PW-Off after leaving it for four hrs., dark current becomes 3mA (Cause of battery drain )
2. Wrong focal distance (in 35mm film equiv.) is recorded in the EXIF data.
757-75 to 757-76
The update corrects the following errors:
1. The stray light is exposed when it exposes for 40 seconds with BULB, NOISE REDUCTION OFF and ISO400.
757-76 to 757-77
The update corrects the following errors:
1. When the external flash is used, the flash charging indicator is not on after the flash firing.
2. Using the card which has block failure may cause a camera hang-up.
3. Pixel Mapping does not function well.
4. When the camera is used in SDK mode, the Camera Control cannot be used.
757-77 to 757-78
The update corrects the following errors:
1. When the lens of camera with FL-50 is set to wide side, zoom values below 35mm are not displayed.
2. The minimum aperture of RAW data is not correctly indicated in any application software.
Strona: http://www.molon.de/8080/#Firmware
Co Wy na to?
Odpowiedz z cytatem
